Key takeaways
-
Magnetostrictive scalers use interchangeable inserts and an elliptical tip motion where all sides of the tip are active.
-
Piezoelectric scalers use screw-on tips with a linear motion. The lateral sides are the active surfaces.
- Magnetostrictive inserts are 25K or 30K. They must match the unit's frequency.
How ultrasonic scaling works
An ultrasonic scaler vibrates the tip thousands of times per second. Combined with water flow, the vibration breaks up calculus and disrupts biofilm, while the water cools the tip and flushes debris. Compared with hand scaling alone, ultrasonics can make debridement faster and reduce operator hand fatigue.
Magnetostrictive vs. piezoelectric
|
Magnetostrictive |
Piezoelectric |
| Tip motion |
Elliptical. All sides of the tip are active |
Linear (back and forth). The lateral sides are active |
| Working end |
Removable inserts (metal stack or ferrite rod) |
Screw-on tips, tightened with a torque wrench |
| Frequency |
25,000 or 30,000 cycles per second (25K / 30K) |
Typically higher (around 25–50 kHz depending on unit) |
| Handpiece heat |
Insert generates some heat, so needs adequate water flow |
Handpiece generally stays cooler |
| Familiarity |
Very common in US hygiene operatories |
Very common internationally |
25K vs. 30K: magnetostrictive inserts must match the unit's operating frequency. A 30K insert in a 25K unit, or the reverse, will not perform properly. Check your unit before you order inserts.
Scalers and accessories we carry
Need inserts? We stock Flight 30K scaler inserts in several designs, and built-in scaler modules such as the Flight built-in ultrasonic scaler for delivery units.
Standalone or built-in?
-
Standalone units sit on the counter or a cart. They are easy to move between operatories and simple to service.
-
Built-in scalers integrate into the delivery system. They keep the counter clear and share the unit's water and foot control.
-
Portable setups: many portable dental systems include an integrated scaler.
Air polishing: the hygiene companion
Air polishers use a stream of air, water and fine powder to remove stain and biofilm. Woodpecker handpieces and powders are popular choices:
Care and maintenance tips
- Flush water lines at the start of each day and between patients, following your waterline maintenance protocol.
- Check inserts and tips for wear. A worn tip loses efficiency, so use a wear guide.
- Inspect O-rings on magnetostrictive inserts and replace them when they're worn or leaking.
- Sterilize inserts, tips and handpiece sheaths between patients as the manufacturer directs.
- Use an inline water filter where recommended, such as Cavitron in-line filters.
Frequently asked questions
Which is better, magnetostrictive or piezo?
Neither is universally better. It comes down to clinician preference, training and the procedures you perform. Many hygienists trained in the US prefer magnetostrictive, while piezo is widely used elsewhere.
How do I know if my unit is 25K or 30K?
It is usually marked on the unit or in its manual. Inserts are also marked 25K or 30K. If you're not sure, send us the model and we'll check.
How long do scaler inserts last?
It depends on use. Inspect them regularly with a wear guide. Tips worn by just a few millimeters lose a significant share of their efficiency.
Upgrading your hygiene operatories?
We'll match scalers, inserts and accessories to your existing units.
Request a Quote
Shop: Ultrasonic Scalers · Vector · Vakker Dental · Read next: Dental Handpieces Explained
Comments (0)