Foredom M.LXH Bench Motor with Square Drive Shafting choice of Speed Control with Warranty

M.LXB Motor permanent magnet motors are specifically designed for high torque/low speed applications, offering more power for jobs like stone setting, wax modeling, and pearl drilling. M.LX, M.LXM, and M.LXB ball bearing motors feature full power and torque from start up and throughout the entire speed range up to 5,000 rpm. They are ideal for use with Foredoms drill presses. They also are well matched with the H.15 and H.15D Hammer Handpieces. It comes equipped with our standard 39" long key tip shafting for connecting to any of Foredoms quick disconnect handpieces.

M.LXB motors are available in 115 Volt and 230 Volt.

These controls have the same housing as other Foredom speed controls but they convert AC current from an electrical outlet to DC current required by Series LX motors. These controls have a different style plug that is made to fit the motor's shielded-type plug. Damage will result if the motor is connected to any other speed control.

M.LXBH-TXR has:

C.TXR-1 Speed Control foot operated speed control is made of heavy duty plastic with durable solid state electronics. The ergonomics allow precise and reliable speed control with your foot. For use with 115 Volt M.TX, M.TXB, M.TXH, M.LX, M.LXB, M.LXH and M.LXBH motors. 7" long, 4-12" wide, 2-38" high, ship wt 2 lbs./1 kg.

M.LXBH-SXR has:

C.SXR-1 Speed Control has durable, solid state electronics as the C.TXR-1. The ergonomics allow precise and reliable speed control with your foot. The C.SXR-1 has special electronics that converts AC current from an electrical outlet to DC current- the type required by the motor. It also has a special plug that fits the motor's shielded plug. 6-3/4" long, 4" wide, 2-3/8" high, ship wt-6 lbs./2.7 kg.

M.LXBH-EMX has:

C.EMX-1 Speed Control is a solid state control in a plastic housing that can be positioned anywhere on a work surface. The hand dial is used to adjust and set speed. This manual style control allows you to maintain and return to a desired speed, time and again by marking the setting on the dial. The C.EMX-1 also has a replaceable fuse that protects the electronics during power surges and work overloads. 5" long, 5-34" wide, 2-58" high, ship wt 2 lbs./1 kg.

Square drive Series LXBH flex shafts feature a 63" long, heavier square drive shaft and protective sheath in place of the standard key-tip shaft and sheath. Square drive shafting ONLY works with Foredom's 4 square drive handpieces- the H.25H, H.30H, H.44HT and new H.28H.

M.LXBH motors are available in 115 Volt and 230 Volt.

Handpieces are available separately and Required to Operate your Flex Shaft Machine. H.25H, H.30H, H.44HT and H.28H are Foredom's four square drive handpieces that work with this motor-speed control combination and are shown below under Related Products.