جهاز تحليل الرطوبة LMA100-SET-P Mark3 HP من Sartorius / تم إيقاف إنتاج المنتج

Mark 3 HP Moisture Analyzer with printer, consisting of :

• Control module LMA100PA-000U with integrated printer
• Heater module LMA100PQ-000U (0.1 mg, 100 g)
• Optionally available on request: Moisture Analysis Individual service (YMD01P)

Advantages:

• Economical and reliable alternative to Karl-Fischer titration and oven drying methods
• Intuitive operation - learn to use the analyzer in just minutes
• Only a touch of a button is needed to start a measurement
• Fast and resistant; ideal for routine operations
• Multi-module operation allows parallel measurements of up to 4 different samples on a single analyzer
• A wide range of security configurations guarantees reliable results and 100% traceability

Specification:

• Data printer: Built-in thermal printer
• Integrated calibration weight: Yes
• Data interface: Serial
• Dimensions (WxDxH): 41.3 x 49.5 x 23.5 cm
• Sample Ids: Yes
• Memory data storage: 999 individual results with statistics: average, SD, RSD, high and low
• Display: Quarter VGA with contrast adjustment (black on white or white on black), Sealed membrane keypad with audible tactile feedback
• Readability: 0.1 mg, 0.001%
• Analysis mode: Timer mode, when value falls below a defined weight loss per time unit (% / min), trend shutoff
• Presentation mode for results: Weight,% Moisture,% Solids,% Volatiles, PPM moisture, PPM drying mass
• Heating mode: Standard test, Syringe, "Splash" method or Concentration modes, programmable temperature steps, one or two with selectable ramp rate
• Maximum number of programs: 300
• Password protection: Yes
• reproTEST: Built in reproTEST for determining the repeatability of the weighing system
• Maximum weighing capacity: 100 g
• Recommended humidity range: 0.005 - 99.995%
• Line tension: 90-250 VAC 50/60 Hz self-adjusting power supply
• Modular configuration: Control and Heater modules (Optional: up to 4 heater modules)
• Temperature adjustment: Optional fixture for internal electronic two-point adjustment
• Temperature display: Display of both target and current temp at each stage of testing and standby
• Conserve mode clock: Programmable time by day of week to shut down and wake up analyzer
• Balance module design: Monolithic weighing cell with protective stainless steel cover
• Ideal weight: Audio and visual signal when ideal weight is reached
• Target limit alert: Minimum and maximum programmable limits and screen alert when test done
• Operator names: Twenty alphanumeric operator names
• Graph mode: Graph of temperature and percentage over time
• Heating source: Thermogravimetric, loss on drying, Heat Source: Four parallel infrared quartz cylinders
• Temperature range: 30 degree C - 210 degree C in one-degree increments / RTD sensor, +/- 1 degree C, Standby temperature selectable from 30 degree C - 160 degree C
• Weighing system accuracy: +/- 0.1 mg
• Starting at an initial sample weight of approximately 1 g: ? 0.1%
• Starting at an initial sample weight of approximately 5 g: ? 0.02%
• Approximate weight: 10 kg

Data Sheet
Mark 3 HP Moisture Analyzer - Modular Infrared Moisture Analyzer with Quartz Radiator